I LOVE Zeros sword. That is amazingly detailed and badass.
Any chance you could do Mordecais sword? :3
1 Like
Thank you very very much! 
I still try to built a lifesize sword with LEDs, but electonics are not my friend ^o^’
Uhhhh awesome idea!!! Mordi was my mainchar in BL1. I even tried to craft his sword in lifesize back then, but my crfting skills were to poor… I think nowerdays its a piece of cake - if I´m lucky and have a free hour spare I can post a freshly made Modecai machete soon 
1 Like
Soooo 3 hours of hard work and the paintjob on Nishas Sheriff Badge is finally done! 
Handsculpted from polymerclay and painted in the desired ratched cellshade-style. The glowing core is a intense blue glowing glass cabochon.
LOVED THIS PROJECT!!! Its so much fun to paint in the typical BL-style <3
5 Likes
Do badasses blush?! Yes, they do^^
Thank you!!!
These are all wonderful. Very well done.
Thank you alot! <3
1 Like
Most certainly, though I should be thanking you for all of your good work and then sharing it.
1 Like
Finished keycharms! 
Zer0s sword and 0 + Vaultlogo combined as keycharms
and Mayas legendary COM as openable book locket to put in a photo of your BFF or Coop-player ^.^
with Vaultlogo and a block Eridium^^
2 Likes
I especially like the Sheriff’s badge. I don’t remember whether the blue center is an accurate detail from BL2, but if it isn’t, it’s a detail that should have been there - it’s closely reminiscent of one of Jack’s pieces of equipment and therefore highlights the Jack-Nisha connection.
Either way a nice piece of work.
1 Like
I envy your abilities, congrats!
1 Like
Thank you very much! I love the Badge alot too 
To be honest, I did´nt made a screenshot ingame as usual for references, but used a concept art
I could not decide if I make the center bluish or green, so I asked all people I know to determine which color it might be^^
Is that center bit made out of a marble? Also it does look awesome.
Thanks alot @Krieg_Krazy ! Indeed, thats a round glass stone^^ Its was just perfect for the job, since I´m to lazy/stupid for actual LEDs >.<
Installing an LED into a sphere or a half-sphere is very difficult. Through the glass or plastic the gap between the LED and the sphere will be very noticeable, it would look like a sphere within a sphere, so your design is basically perfect.
Basically I dont see a way to make it light up withought it looking crap when it isnt.
1 Like
Exactly my thoughts! I´m quiet happy to hear this from a fellow crafter, I always thought it might be just a lack of skill on my side ^^’
Did you see the comment above that one, I forgot to tag you in it. It explains why I think it wouldn’t work.
Yes I did, thank you alot for your thoughts! Just tried it with some acrylic orbs I have here at my studio and yes: it looks crappy^^
You have a studio? Bruh, my room is my studio.
1 Like
Same here, but studio is more an euphemism for pure chaos ToT
material everywhere, same for started stuff, halfdone stuff, sometimes I get lost here… I just call it studio because “art-dump” sounds so negative^^
3 Likes